A DIY Buttplug board for orgasm/arousal detection

A Kinky Makers Community project

Created and maintained by Elims

This is a BETA PROJECT

That means that it has not been completely tested or validated, and that it is still in development! Please only purchase if you accept it is not a fully operational design yet.

 GitHub Project Documentation can be found here

The board has onboard a pressure sensor for measuring pelvic floor contractions, which is the common method for predicting arousal level and orgasm.

There is also:

• 3 Axis accelerometer, 3 axis gyroscope, 3 axis magnetometer
• 2 Channel motor driver
• ESP32 with WiFi and Bluetooth
• LiPo charger and battery gauge
• 2x RGB LEDs

Bill of Materials required for project

• SmartAss PCB (This pre-order)
• Vibrating motor (small) or Vibrating motor (Medium)
• LiPo Battery (8.5mm x 20mm x 40mm max size) - check polarity!
• Silicone Tubing 2mm ID, 3mm OD - 0.5mm wall thickness
• Tube Support Inner Spring - 2mm x 45mm (0.2mm thick)
• Tube Support Outer Spring - 4mmx10mm (0.4mm thick)
• 2x Phillips self tapping Screws - 2mmx6mm
• 3D printed parts